|
|
Post by highcountry on Nov 28, 2009 13:01:53 GMT -5
New to dirt ovals wanted to know what would be the best conversion kit to buy for my RC10GT to convert to dirt ovals, i will be running a Kipp Body.
|
|
|
|
Post by speedys on Nov 28, 2009 13:11:43 GMT -5
the 1312 will be the best kit for a EDM body. you will want to get a set of B4 shocks for the front and rear.
|
|
|
|
Post by highcountry on Nov 29, 2009 11:21:39 GMT -5
Thank You
|
|
|
|
Post by highcountry on Dec 1, 2009 22:47:47 GMT -5
One more Question, will i need to change the a arms out
|
|
|
|
Post by speedys on Dec 7, 2009 14:01:59 GMT -5
No you do not have to change the arms for the kit
|
|
|
|
Post by highcountry on Dec 9, 2009 15:21:33 GMT -5
Should I change the A Arms out?
|
|
|
|
Post by speedys on Dec 10, 2009 21:45:57 GMT -5
Hello highcountry
i am not sure what class you trying to build a gt truck chassis. if you are trying to get the wheel width under 10 inches. yes you will have to change to somebodys a-arms.
|
|
|
|
Post by highcountry on Dec 21, 2009 10:54:04 GMT -5
One more thing i have purchased a set of B4 shocks but i think i was hosed they are about about the same as my stock GT shocks so can i use the front gt for the rear and the front B4 for the front. i am just trying to set it up to run at as many places i can just a general Nitro EDM/Truck class.
|
|
|
|
Post by speedys on Dec 23, 2009 21:34:36 GMT -5
You really need the shocks to be the fronts used on the B4 to use the kit. You can take off the bottom shock mounting bracket. that is bolted to the rear a-arms. Then mount the shock eyelet to one of the mounting holes. If the rear truck set's level that will be close enough. you do not want to compress the rear springs to much. also you can change the shafts and go with a shorter shock shaft. the part number is ASC 9723 .80 shock shaft. you will also have to change the springs to make this all work.
|
|
